Siemens SINAMICS G120D - Page 54

Commissioning
4.2 Commissioning with the IOP
Getting Started
52 Getting Started, FW V4.5, A5E03404762A AB
16. Set the Minimum Speed at which the attached motor
should run.
%DVLF&RPPLVVLRQLQJ
0LQLPXP6SHHG

USP



17. Set the Ramp Up time in seconds.
This is the time the Inverter/motor system will take from
being given the run command, to reaching the selected
motor speed.
%DVLF&RPPLVVLRQLQJ
5DPS8S

V



18. Set the Ramp Down time in seconds.
This is the time the Inverter/motor system will take from
being given the OFF1 command, for the motor to reach
a standstill.
%DVLF&RPPLVVLRQLQJ
5DPS'RZQ

V



19. A summary of all the settings is display.
If the settings are correct, select Continue.
%DVLF&RPPLVVLRQLQJ
6XPPDU\RI6HWWLQJV
&RQWLQXH
)DFWRU\5HVHW1R
&RQWURO0RGH9IZLWKOLQHDU
0RWRU'DWD(XURSH+]N:
&KDUDFWHULVWLF+]
0RWRU9ROWDJH9

20. The final screen gives two options:
 Save settings
 Cancel Wizard
If save is selected, a factory reset will be performed then
the settings are saved to the Inverter memory. The
location of safe data is assigned using the "Parameter
saving mode" function in "Parameter settings" in
"Menu".
%DVLF&RPPLVVLRQLQJ
6HWWLQJVVDYHGVXFFHVVIXOO\
3UHVV2.WRFRQWLQXH
