Siemens SINAMICS G120P CU230P-2 - Page 20

Installing
3.5 Default setting of the interfaces
CU230P-2 Control Units
20 Compact Operating Instructions, 01/2017, A5E38815802B AA
Default setting 18: "2-wire (forward/backward 2)"
DO 0: p0730,
DO 1: p0731
AO 0: p0771[0],
AO 1: p0771[1]
DI 0: r0722.0, …, DI 2: r0722.2 AI 0: r0755[0]
Speed setpoint (main setpoint): p1070[0] = 755[0]
Designation in the BOP-2: 2-wIrE 2
Default setting 19: "3-wire (enable/forward/backward)"
DO 0: p0730,
DO 1: p0731
AO 0: p0771[0],
AO 1: p0771[1]
DI 0: r0722.0, …, DI 4: r0722.4 AI 0: r0755[0]
Speed setpoint (main setpoint): p1070[0] = 755[0]
Designation in the BOP-2: 3-wIrE 1