2 Configuring the hardware
Integration of a SINAMICS G120X frequency converter in PCS 7
Entry ID: 109793986, V1.0, 09/2021
© Siemens AG
2021 All rights reserved
5. The topology configuration is complete. Confirm with "OK" and acknowledge
the warning message with "Yes".
Figure 2-10
6. Save the hardware configuration and compile it.
7. Download the hardware configuration to the CPU.
8. Check that the PROFINET name was transferred correctly.
To do this, switch to the Online view in the hardware configuration.
"Station -> Open online"
To check whether the target topology and actual topology are identical, you have
to access the PG/PC interface and select the Ethernet network adapter with
access to the fieldbus. You can then check the topology in the Topology Editor
with "Compare offline/online".
To Next Page
Loading...
