Installation
5.2 Initial set-up
Intelligent Operating Panel 2 (IOP-2)
Operating Instructions, 06/2020, FW V2.6, A5E39549448B AH
21
The settings for time are normally done on the Control Unit if it has a Real-time Clock (RTC). If
the Inverter has an RTC the IOP-2 will take its settings from the Control Unit.
Lighting duration
To set the length of time that the display remains lit, the following actions should be
performed:
Select Lighting duration time
Press and hold down ESC for
Status Screen
Note
Screen will flash when an active fault condition exists
When an active fault condition exists on the IOP
-2, if no key has been pressed for more than
one minute then the screen will start to flash on and off. The screen will dim a few seconds
prior to the lighting duration time
-out period. If the screen is set to never dim, that is, it has
been set to "Always on" the screen will not dim.
To Next Page
Loading...
