Setup Menu
6.1 Example Setups
Intelligent Operating Panel 2 (IOP-2)
28 Operating Instructions, 06/2020, FW V2.6, A5E39549448B AH
6.1 Example Setups
Overview of Setup
The following example of how Setup work on the IOP-2 are purely for demonstration purpose
only.
Before setting up an application
Prior to using Setup, it is essential that the user's Control Unit and Power Module have been
installed and wired correctly, in accordance with the requirements of the user's application.
This is extremely important in the case of setting up safety-integrated applications. All
inputs and outputs must be defined and configured before any setting up can take place,
including the observation and adherence of all local, national and international safety
regulations required for the user's application and all devices utilized by the user's
Quick Startup/Advanced Startup
Quick Startup
The Quick Startup procedure is all the user needs to setup the converter in quickly and easily.
The Quick Startup allows the user to configure the following converter data:
• Motor Standard
• Motor Type
• Supply Voltage
• Motor Current
• Motor Power
• Motor Speed
• Motor Voltage
• Motor Frequency
• Minimum Frequency
• Maximum Frequency
• Ramp-up Time
• Ramp-down Time
• I/O Setup
The default settings of the converter will be automatically read into the IOP-2, but it is
recommended that you check that these settings are correct for your converter by comparing
the settings with the data from the converter and motor rating labels.
To Next Page
Loading...
