Siemens SINAMICS IOP-2 - Diagnostics

Menu
8.2 Diagnostics
Intelligent Operating Panel 2 (IOP-2)
48 Operating Instructions, 06/2020, FW V2.6, A5E39549448B AH
8.2 Diagnostics
Diagnostics menu
When the diagnostic function is selected the following options are presented:
•
Active faults/alarms
•
History
•
Identification/Maintenance
•
I/O status
•
Communications status
•
I/O simulation
•
Drive enables
Active faults/alarms
When this option is selected the screen will display any active
faults and alarms that have not yet been acknowledged.
Each fault and alarm can be selected and by pressing the INFO
key
or the OK key, an explanation of the fault or alarm will be
displayed.
History
When this option is selected the screen will display a list of all
previous faults and alarms with the time that they occurred.
Each fault and alarm can be selected and by pressing the INFO
key
or the OK key, an explanation of the fault or alarm will be
displayed.
Identification/Maintenance
Displays specific technical information regarding the Control
Unit and Power Module to which the IOP
-2 is attached will be
displayed. The actual information displayed depends on the
type of Control Unit and Power Module to which the IOP
-2 is
connected.