Intelligent Operating Panel 2 (IOP-2)
Operating Instructions, 06/2020, FW V2.6, A5E39549448B AH
71
9.1 Door mounting kit
Door mounting kit
The door mounting kit (DMK) has been designed to allow the IOP, IOP-2 or BOP-2 to be
mounted into the door of a cabinet.
The Operator Panels (OP), when installed correctly in the door of the cabinet, provide the
following IP ratings around the DMK:
• IOP: IP54
• IOP-2: IP55
• BOP-2: IP55
There are two types of mounting screws, one is designed for use with the brass insert on the
back of the OP and the other is thread-forming screws which is to be used on the OP without
the Brass inserts.
The fitting of the DMK is accomplished as shown in the figures below.
Figure 9-1 Fitting Operator Panel (brass inserts)
To Next Page
Loading...
