Siemens SINAMICS IOP-2 - HAND;AUTO Disable

Control menu
7.6 HAND/AUTO disable
Intelligent Operating Panel 2 (IOP-2)
44 Operating Instructions, 06/2020, FW V2.6, A5E39549448B AH
Setting up Startup in Hand mode example
Select Control
Select Startup in Hand Mode
Set the required speed
setpoint as a percentage
value
The IOP-2 will automatically return to the Control menu and show that "Startup in Hand
Mode" is "On".
The converter, after a power-cycle will automatically startup in Hand mode, but the attached
motor will not run until the run command is given by the buttons on the IOP-2.
7.6 HAND/AUTO disable
Overview
The HAND/AUTO disable function disables the HAND/AUTO key on the Intelligent Operator
Panel (IOP-2) and pressing the key will not produce any action by the IOP-2.
An example of setting up the Hand/Auto disable mode is given in the instructions below.
Setting up the HAND/AUTO disable function
Select Control
Select Hand/Auto Disable
Enter password (default:
00000000)