Siemens SINAMICS IOP-2 - Page 47

Control menu
7.6 HAND/AUTO disable
Intelligent Operating Panel 2 (IOP-2)
Operating Instructions, 06/2020, FW V2.6, A5E39549448B AH
45
Select On: Hand/Auto from
PLC or DI
Enter password again or
create a new password
Select signal source
Select input to receive control
signal
Press ESC to return to Control
Menu
The HAND/AUTO button is now disabled and local control of the IOP-2 cannot be activated by
the HAND/AUTO button. In this example, the converter is now setup to receive the
HAND/AUTO command from Digital Input 1 (DI1).
Note
Power
-cycle required to complete the HAND/AUTO disable function
When the HAND/AUTO disable function is initiated the function will not become active until a
power
-cycle of the IOP-2 has been performed. When the HAND/AUTO disable function is
turned off, again, a power
-cycle of the IOP-2 is required to complete the deactivation of the
function.