Siemens SINAMICS IOP-2 - Initial set-up

Installation
5.2 Initial set-up
Intelligent Operating Panel 2 (IOP-2)
18 Operating Instructions, 06/2020, FW V2.6, A5E39549448B AH
5.2 Initial set-up
Initial set-up sequence
Once the IOP-2 is fitted and powered-up it will automatically detect the type of Control Unit
and Power Module to which it has been fitted. On first-time use, the IOP-2 automatically
displays the option to select the default language and allow the time and date to be set (if the
Control Unit to which the IOP-2 is fitted has a real-time clock). The IOP-2 will then display the
choice between "Quick Startup" or Advanced Startup"; "Quick Startup" is the recommended
selection. The procedure is outlined below.
Note
Saving and cloning of the IOP
-2 configuration data
All changes made to an IOP
-2 configuration, included all saved parameter sets, are stored in
the IO
P-2 file structure in the "user" folder.
To copy/clone all this data to another, or multiple IOP
-2s, the procedures are shown in
Customer parameter sets (Page 61).
Splash screen is displayed
Select the required language
Select date format
Set correct date and time
Select Quick Startup
Select "Yes, reset to factory
settings"