Setup Menu
6.1 Example Setups
Intelligent Operating Panel 2 (IOP-2)
Operating Instructions, 06/2020, FW V2.6, A5E39549448B AH
29
Advanced Startup
The Advanced Startup provides the user with a more comprehensive range of settings that
can be configured for specific requirements and applications. The settings that are available
are as follows:
• Drive Information: This displayed detailed information about the connected Control Unit
and Power Module.
• Factory Reset: This allows the converter to be reset to the factory default settings.
• Hardware options: This allows the configuring of and Output Filter and a Braking Resistor.
• Control Type: This allows the selection of the control types, Standard Drive Control,
Dynamics Drive Control and Expert. A brief explanation of each Control Type is given
below.
• Motor Data: This allows the user to configure the Motor settings which consist of the data
presented in the Quick Setup.
• Limit Settings: This gives the user the opportunity to setup the dynamics settings of the
converter.
• Optimization: This allows the user to optimize the converter for technological applications
and ensure that the correct motor data will be used.
• I/O Setup: This allows the user to configure the Input and Output settings of the converter.
The I/O configuration is pre-assigned using macros so that no further settings are
necessary.
• Fieldbus Setup: This allows the user to configure the interface settings.
• Application Setup: This allows the user to configure the application specific functions of
the converter.
For more detailed information of the application classes, see the document at the link below:
Application classes (https://support.industry.siemens.com/cs/ww/en/view/109480663
)
Control Types
Standard Drive Control
• Standard Drive Control is preset for the Power Modules PM240, PM240-2 and G120C in
frame sizes FSA-C. This application class can, for example, be used for the following
applications:
– Pumps, fans and compressors with flow characteristic
– Wet or dry beam technology, mills, mixers, kneaders, crushers, agitators
– Horizontal conveyor technology (conveyor belts, roller conveyors, chain conveyors)
– Basic spindles
To Next Page
Loading...
