Siemens SINAMICS IOP-2 - Page 68

Menu
8.7 Extras Menu
Intelligent Operating Panel 2 (IOP-2)
66 Operating Instructions, 06/2020, FW V2.6, A5E39549448B AH
Default dataset
This option allows the user to determine which is the default
command dataset when viewing or selecting a new default
dataset from the options provided.
Note:
Some applications require that both co
mmand datasets be
used at the same time. On the IOP
-2 to access the
parameters for both command datasets, then the command
datasets screen must be set to "No default Command
Dataset".
If the IOP
-2 is not set to "No default Command Dataset" then
only one co
mmand dataset will be visible to the IOP-2 in the
parameter settings.
Parameter saving mode
This option allows the user to set the default location for any
save function performed on the converter.
Save RAM to ROM
This option allows the user to manually save all drive data
from the converters internal memory to the internal non
-
volatile memory
- thus data save will be retained within the
conver
ter until it is overwritten.