Siemens Sinamics PM250 - Control Unit installation

Installing/mounting
4.4 Control Unit installation
PM250 Power Module
Hardware Installation Manual, 01/2016, A5E36265179B-AA
25
4.4
Control Unit installation
Plug the Control Unit onto
the Power Module as shown
in the diagram. By plugging
on the Control Unit, you also
establish all of the electrical
connections between the
Control Unit and
the Power
Module.
Press the release button on
the Power Module to remove
the Control Unit.
4.5
Installing supplementary components
Depending on the particular application, additional components may be required for your
system. Information about additional components is provided in the following Sections:
Connection overview (Page 34)
Optional accessories (Page 70).