CAUTION
Risk of falling
When climbing onto the cover of the anti-condensation heating there is a risk of injury.
Therefore,
do not use the anti-condensation heating system to help you get to the top of the
cabinet.
NOTICE
Non-approved spare parts
Using
non-approved spare parts can affect the function of the equipment and damage it. Third-
party spare parts and unapproved spare parts may not meet the requirements.
Therefore, only use spare parts that have been approved by the manufacturer.
NOTICE
Foreign bodies in the drive
If, after installation and maintenance work, foreign bodies are left in the drive, this can damage
it when switching on.
Before switching on, check as to whether there are any foreign bodies in the drive. Remove
any foreign bodies.
NOTICE
Contamination
Contamination and dirt can damage the device.
Visually inspect the equipment at least once per year. For more information, please refer to
the section "Visual inspections".
Dust deposits inside the cabinet unit must be removed at regular intervals (or at least once
a year) by qualified personnel in line with the relevant safety regulations.
Note
The actual intervals at which maintenance procedures are to be performed depend on the
environmental and operating conditions. Define maintenance intervals for the drive which
reflect your plant-specific environmental and operating conditions and meet your availability
requirements. When doing so, take the prescribed maintenance intervals into consideration,
as well as the instructions for repairing and replacing installed components.
Servicing
8.1 Safety instructions for maintenance
Applications for Cabinet Modules, liquid cooled
106 Operating Instructions, 04/2015, A5E35974555A
To Next Page
Loading...
