To extract the load securing device, proceed as follows:
1.
Remove the retaining straps.
2. Remove the spacers such as wooden wedges, air cushions, etc.
3.4.3 Lifting the cabinet units off the transport pallet and installing them
You can remove the screws that attach the unit to the transport pallets without having to lift
the cabinet unit. Red marks indicate the positions of the fixing screws.
① Fixing screws for units without base
② Fixing screws for units with base
③ Cover
Figure 3-9 Transport pallet screws
Proceed as follows to release and remove the fixing screws:
●
For cabinet units without base ①, release the fixing screws from the lower side of the
transport pallet.
● For cabinet units with base ②, open cover ③ – and then release the screws from the front.
See also
Take the center of gravity into account (Page 50)
3.4.4 Checking the shock and tilt indicators inside the cabinet.
Shock and tilt indicators are also located inside the cabinet. Check these as soon as you have
unpacked and opened the device. To perform the check, proceed as described in "Check shock
and tilt indicators"
Preparations for use
3.4 Unpacking the cabinets
Applications for Cabinet Modules, liquid cooled
Operating Instructions, 04/2015, A5E35974555A 57
Siemens Drives & PLCs
To Next Page
Loading...
