5.3 Step 1: Restoring the factory settings
Procedure
1.
Go to the menu items "Project > Connect to selected target devices" to switch to online
mode.
The window "Target Device Selection" opens and lists the configured drive units.
Figure 5-1 Access point control
2. Activate the "DEVICE" option.
3. Activate the check box " S120_CU320_2_DP" and click on "OK".
The PG/PC establishes the link to the Control Unit.
The PG/PC performs an "online/offline comparison".
The result is displayed in the following dialog "Online/offline comparison".
Example:
Figure 5-2 Online/offline comparison
Commissioning
5.3 Step 1: Restoring the factory settings
Motor Modules Booksize parallel connection
Application Manual, 01/2020, 6SL3097-5BF00-0BP0 35
To Next Page
Loading...
