Siemens SINAMICS V20 Series - Page 252

Options and spare parts
B.1 Options
SINAMICS V20 Inverter
252 Operating Instructions, 07/2012, A5E03728167
Button functions
Button Description
Stops the inverter
Button functions the same as the button on the built-in BOP.
Starts the inverter
Button functions the same as the button on the built-in BOP.
M
M
Multi-function button
Button functions the same as the
M
M
button on the built-in BOP.
OK
Pressing the button:
Button functions the same as the
OK
OK
button on the built-in BOP.
Turning clockwise:
Button functions the same as the
button on the built-in BOP. Fast turning
functions the same as long press of the
button on the built-in BOP.
Turning counter-clockwise:
Button functions the same as the
button on the built-in BOP. Fast turning
functions the same as long press of the button on the built-in BOP.
Button functions the same as the
OK
OK
+
M
M
buttons on the built-in BOP.
Inverter status icons
These icons have the same meaning as the corresponding icons on the built-in
BOP.
Commissioning icon. The inverter is in commissioning mode (P0010 = 1).
Screen display
The display of the external BOP is identical to the built-in BOP, except that the external BOP
has a commissioning icon
which is used to indicate that the inverter is in commissioning
mode.
On inverter power-up, the inverter-connected external BOP first displays "BOP.20" (BOP for
the SINAMICS V20) and then the firmware version of the BOP. After that it detects and
displays the baudrate and the USS communication address of the inverter automatically.
See the following table for settable baudrate and address values. To change the baudrate,
set P2010[1]. To change the USS communication address, set P2011[1].