Table of contents
General information
1.1 System overview ..........................................................
1.2 Safety notes..................................................................
1.3 Identification..................................................................
1.4 Technical data..............................................................
Installation
2.1 Mechanical installation..................................................
Commissioning
3.1.1 Main menu...................................................................
3.1.2 Function menu.............................................................
3.1.3 Setpoints from NC.......................................................
3.1.4 First commissioning.....................................................
3.1.5 System commissioning................................................
3.1 Commissioning............................................................
3.2 Parameter list................................................................
Troubleshooting
EN-3
EN-4
EN-6
EN-8
2.1.1 Mounting the drive.......................................................
2.1.2 Mounting the motor......................................................
2.2 Electrical installation.....................................................
2.3 Interface definition.........................................................
4.1 LED status indicators.....................................................
4.2 Alarms...........................................................................
4.3 Errors during drive self-test...........................................
4.4 Other faults....................................................................
1-NEdetratS gnitteG )1.06MPC( eludoM rewoP dellortnoC 06V SCIMANIS
EN-10
EN-19
EN-25
EN-19
EN-20
EN-22
EN-23
EN-24
EN-10
EN-12
EN-12
EN-16
2.4 Signal sequence example.............................................
EN-18
EN-29
EN-29
EN-32
EN-32
中文版请见第 CHS-1 至 CHS-34 页。
For the Chinese version, see pages CHS-1 to CHS-34.
CPM 的固件（软件）已更新为 V1.7。当前驱动器在缺省状态下较旧版具有更强的动
态性。如需回到旧版工作状态，可将当前缺省值重设为第二缺省值（见 3.1.2 节）。
The firmware (software) in the CPM is already updated to V1.7. Now the perfor-
mance of the drive in the default status is more dynamic than that of the old version.
If you want the drive to work in the old status, you can change the current default
value to the second default value (see section 3.1.2).
To Next Page
Loading...
