Siemens SINAMICS V60 - Alarms; LED Status Indicators

4
4.1 LED status indicators
4.2 Alarms
Descriptions of LED status indicators
H1
H2
Description
RDY/JOG
Green LED
ERR red LED
7-segment LED
display description
Overview of alarms
”nur-J“ yalpsiDedom GOJkraDFlash light with 1 Hz
A45
A44
A43
A42
A41
A23
A22
A21
A14
A09
A08
A07
A06
A05
A04
A03
A02
A01
Emergency stop
I
2
t protection
Enable signal from Terminal 65 is lost during normal drive running
Signals from encoder phases U, V, W are detected all the same (all high or all
low)
Actual motor speeds is higher than 2,300 rpm
DC link voltage is lower than 200 V
DC link voltage is higher than 405 V
Encoder TTL signals error
Encoder UVW signals error
Software failure
TTL pulse error
IGBT current exceeds the upper limit for 300 ms
Grounding short circuit occurs during drive initialization
Internal chip is detected overcurrent
IGBT is detected overcurrent
Control voltage is lower than 3.5 V
Unable to write data to memory
Parameter validation error (CRC error, encoder type or parameter header
invalid)
Unable to identify the power board
Power board ID number error
DescriptionAlarm nameAlarm code
Parameter error
Memory-write failure
Control voltage error
IGBT overcurrent
Internal chip overcurrent
Grounding short circuit
IT protection
DC link voltage undervoltage
DC link voltage overvoltage
Internal error
Overspeed
IGBT becomes overheatingIGBT overtemperature
Motor load exceeds nominal motor torque
Following error exceeds the limit
Following error too big
DarkDark
Dark
Dark
Green
Green
Dark
Red
Red
Drive ready
Drive error
Initialization Display “8.8.8.8.8.8.”
Alarm code
Dark No 24 V DC input or drive defect
Flash light with 1 Hz Drive not ready Current status
Depends on current menu operation
M
ENTER
Possible states
LED RDY / JOG (Ready / JOG mode)
Possible states
LED ERR (Error)
Dark
Flashing green
Lit green
Dark
Lit red
Flashing red
SINAMICS V60 Controlled Power Module (CPM60.1) Getting Started EN-29