Siemens SINAMICS V60 - Signal Sequence Examples

3.1.2 Function Menu
NOTICE
Descriptions of main keys:
Key Definition Function
M
ENTER
Mode selection
Enter
Switch between 4 main menu items (Status, Parameter Set , Data
Display and Function) or return current display to next higher-level.
Go to next lower-level menu item or back to higher-level item, confirm
value (save modified value into RAM) or cancel an alarm.
Accessibility to "JOG" mode or 'Save user parameter" mode (see the picture above) depends on the
current display status of the drive:
when the drive is in "S-3" (waiting for 65 enable) state and P05 = 1, access to JOG mode is possible.
Please save modified parameters via the Store function in the function menu, otherwise, the parameter
changes will be lost if the drive is powered off. It must be noted that signal of servo enable (terminal
X6-"65") or signal of pulse enable (terminal X5-"+ENA"/"-ENA") should be cut off if you try to save the
EN-20 SINAMICS V60 Controlled Power Module (CPM60.1) Getting Started
Function Menu
Save user
parameter
Restore
default
ENTER
JOG
No
ENTER
or
or
ENTER
ENTER
M
or
Status
Parameter Set
Function
Data Display
M
M
M
M
M
ENTER
or
M
M
ENTER
or
M
ENTER
or
The default menu item
under current menu level
or
If the current drive operating status supports JOG
funtion, “JOG RUN”will be displayed.
Otherwise, “Forbidden” will be displayed.
Keeping Up key pressed can make the motor run
counter-clockwise.
Keeping Down key pressed can make the motor run
clockwise
Releasing the key can stop the motor.
Key release
Yes
Forbidden
Forbidden
Finish
JOG RUN
JOG RUN
JOG RUN
If the current drive operating status
supports “Save user parameter”
function, “Finish” will be displayed.
Otherwise, “Forbidden” will be
displayed.
If the current drive operating status supports
“Restore default” function, “Finish” will appear.
Otherwise, “Forbidden” will appear.
Key release
Restore
default
the second
No
ENTER
or
or
ENTER
ENTER
M
or
M
or
M
ENTER
or
Yes
Forbidden
Finish
No
ENTER
or
or
ENTER
ENTER
M
or
M
or
M
ENTER
or
Yes
Forbidden
Finish
The 2nd default values are the default values of FW V1.6 and the lower.