Siemens SINAMICS V60 - Commissioning; Main Menu

3
3.1.1 Main Menu
3.1 Commissioning
Displays and settings
The status menu items
Commissioning
Main Menu
Status
Parameter Set
Function
Data Display
M
M
M
M
ENTER
......
......
......
To cancel the alarm,
power off the drive, then
power on again
Normal
status
display
Status-1
Status-2
Status-3
Status-4
Status-RUN
Status-A01
Status-A09
......
Status-A14
Status-A21
Status-A23
Status-A41
Status-A45
...... ......
The default menu item
under current menu level
Actual menu display
Alarm
status
display
Display of the 1st detected alarm
(the alarm no. always contains
a letter “L” to indicate this is the
first alarm.)
Display of the 2nd detected alarm
Display of the 3rd detected alarm
2 sec
2 sec
2 sec
When more than one error occurs at the same
time, the rule for error display is as the following
example:
8.8.8.8.8.8.
S-RUN
Alarm status
Normal status
Menu Item
Definition
Preconditions for display of normal status
S-A01
...
SINAMICS V60 Controlled Power Module (CPM60.1) Getting Started EN-19