Data no. Name Data format Unit Data group
mN tnioptes euqroT *01D
mN euqrot eht fo eulav lautcA *11D
D12* Actual value of the phase
current
Decimal
(See table below)
A
Current
MPR tnioptes deeps rotoM 02D
MPR deeps rotom lautcA 12D
Speed
D30 Position revolution se snoitulover rotoM tniopt
)r/00001( stnemercnI tnioptes elgna noitisoP 13D
D32 Actual position revolu snoitulover rotoM snoit
D33 Actual position ang )r/00001( stnemercnI el
D34 Position deviation angle
Integer
Increments (10000/r)
Position
xeh ni stiB langis tupni latigiD *05D
D51* Digital output signal
Bit (See table below)
Bits in hex
I/O
D80* Firmware version (See table below)
D81 Power Board rated current Integer
D82* Parameter version number (See table below)
HW, FW
* The data type of D10, D11, D12, D80, D82 is all decimal format. The display value for D50 and D51
respectively varies as the case may require.
3.3
Display data list
SINAMICS V60 Controlled Power Module (CPM60.1) Getting Started EN-27
To Next Page
Loading...
