Siemens SINAMICS V60 - Troubleshooting; LED Status Indicators

Press Enter key on
the operator panel
or terminal RST of
X6 interface
Replace the drive with
a new one
Replace the drive with
a new one
Replace the motor with
a new one
Check the maximum
speed limitation (refer to
parameter P26)
Set a wider value range
for the detection of
following error (P34)
Use a drive and motor
with bigger power
Reduce the load
Give more gains
Check the limit value of
current (P16)
Replace the drive with
a new one
Check the ambient
temperature
Ambient temperature is too high
Check the drive load
Check the wiring
Check the wiring
Check the wiring
Replace the drive with
a new one
Check the power supply
Replace the drive with
a new one
Replace the drive with
a new one
The encoder cable is badly
connected
Replace the drive with
a new one
Circuit board fails
Circuit board fails
The drive is overloaded
Encoder fails
Replace the drive with
a new one
Check whether the
brake is open or not
Check the 65 enable
terminal
Circuit board fails
Low speed
No enough torque
The position loop gain is too
small
The maximumly-permitted
following error is too small
The rated torque is exceeded
Command pulse frequency is too
high
The brake is not open
The motor is not stable
The encoder is wrongly wired
The encoder fails
The encoder fails
Emergency
stop (the
motor will
stop with
the
maximum
energy or
torque)
Emergency
stop (the
motor will
stop with
the
maximum
energy or
torque)
Emergency
stop (the
motor will
stop with
the
maximum
energy or
torque)
Emergency
stop (the
motor will
stop with
the
maximum
energy or
torque)
Emergency
stop (the
motor will
stop with
the
maximum
energy or
torque)
Free stop
Press Enter key on
the operator panel
or terminal RST of
X6 interface
This alarm may
occur when the
24 V DC supply
is connected
This alarm may
occur when the
24 V DC supply
is connected
The motor does
not rotate or
reversely rotate
if the command
pulse is input
after DC-link and
mains line are
connected
This alarm may
occur when the
24 V DC supply
is connected
This alarm may
occur when the
DC-link is
connected
This alarm may
occur when the
motor is running
This alarm may
occur when the
motor is running
This alarm may
occur when the
motor starts
running
Press Enter key on
the operator panel
or terminal RST of
X6 interface
Press Enter key on
the operator panel
or terminal RST of
X6 interface
Press Enter key on
the operator panel
or terminal RST of
X6 interface
Press Enter key on
the operator panel
or terminal RST of
X6 interface
1. check the load
2. lower the start/Stop
frequency
3. use drive and motor
with more power
1. Lower the frequency
2. Check whether P36
has the right value
1. modify the gain value
2. lessen load inertia
by RST terminal.
The 65 enable signal is lost
when the motor is running
A23
A41
A42
A43
A44
A45
Alarm
code
Background
Possible Cause Remedy Result Acknowledgement
1. terminas U, V and W on the
motor are wrongly connected
2. encoder cable is wrongly
connected
1. terminas U, V and W on the
motor are wrongly connected
2. the encoder is wrongly wired
1. circuit board fails
2. fuse of the power is burnt out
3. rectifier is boken
1. low supply voltage
2. insufficient supply power
capacity
3. transient power failure
NOTICE
SINAMICS V60 Controlled Power Module (CPM60.1) Getting Started EN-31