Siemens SINAMICS V90 PROFINET - 4 Installation and Startup; Installation of the Hardware; Startup (JOG from Drive Side)

4 Installation and Startup
4.1 Installation of the hardware
Speed Control with SINAMICS V90 and S7-1200 via PROFINET
Entry-ID: 109739222, V1.0, 07/2016
16
 Siemens AG 2016 All rights reserved
4 Installation and Startup
4.1 Installation of the hardware
The figure below shows the hardware configuration of the application:
Figure 4-1
L1
L2
L3
N
PE
M
L1 L2 PE
U V W PN PN
L1 N PE
PN
SINAMICS V90 PN
SIMATIC S7-1200
CPU 1214C
4.2 Startup (JOG from drive side)
Table 4-1
No.
Action
Remarks
1.
Set drive parameter p29108 to be 1.
JOG function is enabled when p29108=1
2.
Switch to JOG menu with drive BOP operation.
3.
Press or button to run the motor.