Siemens SINUMERIK 808D

Cycles
2.4 Drilling cycles
Turning Part 2: Programming (Siemens instructions)
110 Programming and Operating Manual, 05/2012, 6FC5398-5DP10-0BA0
=
;
/HQJWKFRPSHQVDWLRQ
'ULOOLQJD[LV
Figure 2-2 Drilling axis when turning
Dwell time programming
The parameters for dwell times in the drilling cycles are always assigned to the F word and
must therefore be assigned with values in seconds. Any deviations from this procedure must
be expressly stated.
Special features when using drilling cycles on a turning machine
Simple turning machines without driven tools can apply drilling cycles only for drilling on the
end face (with Z-axis) in the turning center. These drilling cycles must always be called in the
G17 plane.
<
=
$%
$






%

<
;
Figure 2-3 Drilling on turning center without a driven tool