Siemens Sinumerik 810T User Manual

11.90 4 Monitoring Functions
4.6 Listing of the alarms/alarm description
Alarm No.
Alarm Text:
26
”Block > 120 characters R232C (V.24)”
Reason:
Effect:
Remedy:
The part program block that has been read in contains more than 120
characters. Only the actual stored characters are counted (no blanks,
no CR, ...)
– Data transfer is interrupted
– The last block is not stored
The block must be divided into 2 or more blocks
Alarm No.
Alarm Text:
27
”Data input disabled R232C (V.24)”
Reason:
Effect:
Remedy:
Interface signal ”Cycle inhibit” is on:
NC, PLC machine data text, PLC alarm text or
PLC program
No data will be stored
Report the problem to Service
Alarm No.
Alarm Text:
28
”Circ. buffer overflow R232C (V.24)”
Reason:
Effect:
Remedy:
Data transfer speed too high
RS232C (V.24) transfer is interrupted, several blocks are invalid
(depends on the block length)
Report the problem to Service
Alarm No.
Alarm Text:
29
”Block > 254 char. R232C (V.24)”
Reason:
Effect:
Remedy:
The block that has been read in has more than 254 characters. All
characters (e.g. blanks) read in are counted.
– RS232C (V.24) transfer is interrupted
– The last block is not stored
The block must be divided into 2 or more blocks
Alarm No.
Alarm Text:
30
”PP memory overflow R232C (V.24)”
Reason:
Effect:
Remedy:
The maximum part program memory space is full
– Data transfer is interrupted
– The last block is not stored
Delete programs that are no longer required, and reorganize memory
Alarm No.
Alarm Text:
31
”No free PP number R232C (V.24)”
Reason:
Remedy:
The maximum number of programs defined by machine data has been
reached.
Delete programs no longer required and reorganize memory or change
machine data (Service).
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 4-9
SINUMERIK 810T, GA3 (BN)

Siemens Sinumerik 810T Specifications

General

Brand	Siemens
Model	Sinumerik 810T
Category	Network Hardware
Language	English