Siemens Sinumerik 810T - Page 308

09.91 8 Appendix
8.2 List of terms used
Term Section
PART PROGRAM 2.5
PLANE 2.5
PLAYBACK 2.5
Playback 3.2.6
PLC ALARM 2.5
PLC/MD 2.5
PLC MESSAGE 2.5
PLC STATUS 2.5
”Position not yet reached” display 2.1.1.2
PROGRAM CONTROL 3.2.3.1
PROGRAM HANDLING 2.5
Program edit 3.1.12
PROGRAM END 2.5
PROG. HANDL. 2.5
Program input 3.1.10
Program input with operator guiding 3.1.10.2
Program interruption 3.2.3.4
Program management 3.1.13
Program memory 3.1.13.8
”Program running” display 2.1.1.2
Program sequencing (OPS) 3.2.3.5
PRG. STP. ON-OFF 2.5
Program stop/Program start 2.1.1.6/2.1.2.1
RS232C (V.24) interface 6.1
Rapid 2.1.1.6
Reference point approach 2.3.2/3.1.2
RENAME 2.5
REORG 2.5
Repositioning 2.3.2
Repositioning (Repos) 3.2.12
RESET 2.5
Reset 2.1.1.6/2.1.2.1
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 8-7
SINUMERIK 810T, GA3 (BN)