Siemens Sinumerik 810T - Page 309

8 Appendix 09.91
8.2 List of terms used
Term Section
Reset with change of mode 2.3.4
ROTAT. ANGLE 2.5
R PARAMETER 2.5
R Parameter 3.1.6
R Parameter setting data 3.1.6
SCALE MODIF. 2.5
Scratching 3.2.13
Search address, block no., word or data 2.1.1.5
Semi-automatic tool compensation offset 3.1.4.4
Semi-automatic zero offset 3.1.5.3
SERVICE AXIS 2.5
SERVICE DRIVE 2.5
SERVICE SPINDLE 2.5
Settable zero offset 3.1.5.1
SETTING DATA 2.5
Setting data 3.1.5/3.1.6/6.4/6.3
SIMULATION 2.5
Simulation 3.1.14
Single block 2.1.1.6/2.1.2.1
SINGLE BLOCK 2.5
SKIP BLOCK ON/OFF 2.5
Softkey functions 2.5
Softkeys 2.1.1.1
SPECIAL BLOCK 2.5
SPECIAL FUNCT. 2.5
SPINDLE 2.5
Spindle setting data 3.1.6
Spindle speed 2.1.1.6
Spindle speed override 2.1.2.1
Spindle stop/spindle start 2.1.1.6/2.1.2.1
8-8 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)