Siemens SINUMERIK 840D sl Installation Manual

If you upgrade SINUMERIK Operate from version 4.5.3 (or older) to version 4.5.4 (or later), you
must delete the existing service entries from the configuration file "systemconfiguration.ini"
manually.
The configuration file can be found in the following directories:
● Windows XP: F:\hmisl\user\sinumerik\hmi\cfg
● Windows 7: C:\Program Files (x86)\Siemens\MotionControl\user\sinumerik\hmi\cfg
● Linux: card/user/sinumerik/hmi/cfg
Procedure
1. Open the "systemconfiguration.ini" file.
2. Delete the following lines:
– SVC013 ...
– SVC014 ...
– SVC015 ...
– SVC017 ...
3. Save and close the file.
4. Delete the following files, if applicable:
– systemconfiguration.ini.453
– systemconfiguration.xml
7.1.6 Client update
7.1.6.1 Client update under Windows
Requirement
If not installed, install the PCU Base Software from 01.04.00.00 before starting the
SINUMERIK Integrate client update.
Procedure
1. Start the PCU in the Windows service mode.
2. Open the installation directory on the PCU.
Installing SINUMERIK Integrate
7.1 SINUMERIK Integrate with SINUMERIK Operate
Manage MyResources, Optimize MyProgramming /NX-Cam Editor
Installation Manual, 12/2019, A5E44672080B AE 143

Siemens SINUMERIK 840D sl Specifications

General

Control Type	CNC
Number of Axes	Up to 31
Max Number of Channels	10
Interfaces	Ethernet, PROFIBUS, PROFINET, USB
Interpolation	5-axis interpolation
Operating Temperature	0°C to 45°C
Relative Humidity	Up to 95% (non-condensing)
Display	TFT color display, various sizes
Programming Languages	DIN/ISO
Safety Features	Safety Integrated
PLC	Integrated PLC S7-300
Drive Interface	SINAMICS S120
Data Storage	CF card, USB
Operating System	Windows-based