Transport, storage and packing
9229 0025 176 0A 7
2019-08-05
Opening the transport unit • Place the transport unit on a level, non-slip and pressure-resistant surface.
• Remove lifting gear or means of transportation.
• Remove plastic wrap.
• Lever out the fasteners from the carton and lift off the carton (see Fig. 2).
• Remove film from the vacuum circuit-breaker.
• In the case of overseas packaging, push the lower film onto the pallet floor.
• Check that the delivery is complete.
• Check vacuum circuit-breaker for damage.
Note
Risk of tipping over due to shift in centre of gravity!
Vacuum circuit-breakers with mounted contact arms may tip onto the contact sys-
tem if not fixed.
Before undoing the belt straps, ensure that the vacuum circuit-breaker is posi-
tioned safely and hook fixing gear to the points marked with crane hooks (see
Fig. 5 to Fig. 7).
Fig. 2 Removing the fasteners from the carton
Note
Damaged components
In the case of damage, such as breaks, cracks, flaking, bent metal parts, dam-
aged plug-in contacts, tears or bare cables, voltage breakdowns can occur.
• Do not use the vacuum circuit-breaker.
• Send it back in its original transport unit (see “Reuse of transport unit”,
page 10).
To Next Page
Loading...
