Replacement of the 15" LCD Color TFT Display 11
Siemens AG SPR2-130.841.03 Page 11 of 20 Siremobil Compact L
Medical Solutions Rev. 02 06.05 CS PS 24
Check of the automatically detected video mode 1
• The basic unit and the monitor cart are connected to each other;
the system is fully functional.
• The Memoskop video frequency is set correctly.
• Scroll to the "Mode Info" menu and select it by pressing the "Enter" key.
• Compare the displayed values, with the values in the table Tab. 1.
• If the values are different to table Tab.1, follow the description "Manual programming"
(page 16).
In the normal case, the signal source and mode will be detected
automatically.
However, if needed, the programming can be done manually.
See "Manual programming"
For systems with 50Hz camera system: the video frequency has
to be programmed to 50Hz.
For systems with 60Hz camera system: the video frequency has
to be programmed to 60Hz.
50 Hz 60Hz Remarks
Mode 614 x 514 640 x 444
Clock 13,839 MHz 13,999 (floating value)
H Freq. 16,301 kHz 16,549 kHz (floating value)
V Freq. 50,002 59,524 +/- 1Hz
Rows 324 278 +/- 4 rows
H Pol None None
V Pol None None
Type SoG/I SoG/I
(Sync on Green /
Interlaced)
PDEN H15/L11 H15/L11
Entry 1 Current 0 Current
Tab. 1
NOTE
NOTE
To Next Page
Loading...
