Configuration
3 Configuration
NOTE:
Your DVR should be completely installed before proceeding. Refer to Chapter 2 - Installation.
3.1 Front Panel Controls
Fig. 17 16-Channel DVR front panel.
The front panel looks and operates much like a VCR combined with a multiplexer.
Many of the buttons have multiple functions. The following describes each button
and control. Take a few minutes to review the descriptions. You will use these to
initially set up your DVR and for daily operations.
3.1.1 Power LED
The Power LED is lit when the DVR is on.
3.1.2 Network LED
The Network LED is lit when the unit is connected with RAS (Remote
Administration System) either via Ethernet or modem.
3.1.3 Backup LED
The Backup LED is lit when data is being backed up using the USB port.
3.1.4 Camera Buttons (1 to 16)
Pressing the individual camera buttons will cause the selected camera to display
full screen. They are also used to enter passwords.
21
Siemens Building Technologies SISTORE AX9 AX16_EN.doc
Fire & Security Products 09.2004
To Next Page
Loading...
Need help?
General
