Configuration
3.5.3 System Check Screen
Highlight System Check in the Main menu and press the
button. The System
Check setup screen appears.
Fig. 29 System Check screen.
z Highlight the box under the On/Off heading and press the
button. This
toggles between On and Off. When it is On, the DVR reports a fault condition if
it does not detect any recording or if there is an alarm during the designated time.
z Highlight the box under the Interval heading and press the
button. A slide bar
appears allowing you to set the check interval from 1 Hour to 30 Days by using
the Left and Right arrow buttons.
z The Status field displays the fault conditions. When it is Good, there was
recording or an alarm occurred during the designated time. When it is Bad,
there was no recording or no alarm occurred during the designated time.
32
Siemens Building Technologies SISTORE AX9 AX16_EN.doc
Fire & Security Products 09.2004
To Next Page
Loading...
Need help?
General
