Siemens SITRANS F M MAG 8000 CT - Features;Version

MAG 8000 & MAG 8000 CT
46
SFIDK.PS.026.D9.02
Features/Version MAG 8000 & MAG 8000 &
MAG 8000 CT basic MAG 8000 CT advanced
Measurering frequency Max. 1/15 Hz Max. 6.25 Hz
(battery power)
Totalizer 3 3
Pulse output 2, max. 50 Hz 2, max. 100 Hz
Communication Add-on Add-on
IrDA Yes Yes
Time and date Yes Yes
Data protection Yes Yes
Data logger Yes Yes
Application identifier Yes Yes
Alarm handling Yes Yes
Meter status Yes Yes
Diagnostics Yes Yes
Battery power management Yes Yes
Insulation test - Yes
Leakage detection - Yes
Meter utilization - Yes
Statistics - Yes
Tariff - Yes
Settle date (Revenue) - Yes
8.2 Features/Version
Siemens Flow Instruments Modbus RTU specification for add-on modules
Device type Slave
Baud rates 1200, 2400, 4800, 9600, 19200, 38400 bits/sec.
Number of stations Recommended: max. 31 per segment without repeaters
Device address range 1-247
Protocol RTU
(Other Modbus protocols like ASCII, Plus or TCP/IP are not supported)
Electrical interface RS 485, 2 wire and RS 232, 2 wire
Connecter type Screw terminals
Supported function codes 1 read coils
3 read holding registers
5 write single coil
16 write multiple registers
17 report slave ID
Broadcast Yes
Maximum cable length 1200 meters (@38400 bits/sec.)
Standard Modbus over serial line v1.0
Certified No
Device profile None
Add-on modules - MODBUS over serial line specification & implementation guide v. 1.0
comply with modbus.org 12/02/02
- MODBUS application protocol specification v. 1.1
modbus.org 12/06/02
Isolation 500 V AC functional isolation of data signals and common
(continued)
Add-on modules must be connected to equipment complying with "Low Voltage Directive" in
order to be considered safe. The isolation within the MAG 8000 & MAG 8000 CT add-on MODBUS
module is only functional isolation.
8. Technical data