Siemens SITRANS LR - PROGRAM Mode Display; Programming; Hand programmer

Page EN-8 SITRANS Probe LR – QUICK START MANUAL A5E32106153
mmmmm
English
PROGRAM Mode Display
Programming
• Set parameters to suit your specific application.
•Activate PROGRAM mode at any time, to change parameter values and set operating
conditions.
• For local programming, use the Siemens hand programmer.
• For programming from a distance, use either a PC running SIMATIC
1
PDM or a HART
handheld communicator.
Hand programmer.
Note: Do not use the handheld programmer at the same time as SIMATIC PDM, or erratic
operation may result.
1.
SIMATIC® is a registered trademark of Siemens AG.
1
2
3
6
1 – Primary Reading (displays parameter value)
2 – Secondary Reading (displays parameter number)
3 – Programming indicator
6 – Auxiliary Reading (displays parameter names for P001 to
P010, if a language is selected. It displays the index value
for indexed parameters, such as P054)
display
hand-held programmer
max. 600 mm
(2 ft)
Key Programming Mode
to
Values
Decimal point
Negative value
CLEAR value
TOGGLE between Units and % on parameter
value
End PROGRAM session and enable RUN mode
Update echo quality parameters
Parameter scroll-up
Parameter scroll-down
DISPLAY opens parameter fields
ENTER the displayed value
For direct access to SITRANS Probe LR,
point the programmer at the
SITRANS Probe LR display and press
the keys. (For detailed instructions, see
the next page.)