Siemens sitrans PROBE LU - SITRANS Probe LU Specifications; Power and Performance Specifications

A5E32081626 SITRANS Probe LU (PROFIBUS PA) – QUICK START MANUAL Page EN-11
mmmmm
English
The handheld programmer
1
To activate PROGRAM mode, point the handheld programmer at the display from a maximum
distance of 600 mm (2 ft), and press the Mode key .
Within Program Mode, the handheld programmer has two modes of operation: Navigation and
Edit.
• Press the Mode key to switch from RUN to PROGRAM and enter Navigation Mode:
the rightmost digit of the menu number flashes and the PROGRAM icon is not visible.
• Press Right arrow a second time to change the mode from Navigation to Edit.
• In Edit mode, the PROGRAM icon appears and flashes.
PROGRAM Mode Display
When you activate PROGRAM mode for the first time in any power cycle, the LCD displays the
first menu. If, during the same power cycle, you switch to RUN mode, and then back to
PROGRAM mode, the LCD will display the menu or item that was last accessed in PROGRAM
mode.
1.
For complete instructions on local programming using the handheld programmer, please see the full
manual.
Note: SITRANS Probe LU (PROFIBUS PA) continues to monitor In and Out values even when
the device is in PROGRAM mode.
display
hand-held programmer
max. 600 mm
(2 ft)
5
9
C
6
0
7 8
1 2 3 4
numeric keys
function
keys
1 – Primary region (displays parameter value)
2 – Menu number region (displays Menu number)
3 – PROGRAM mode icon
4 – Secondary region (displays text label)
1
2
3
4