A5E32081626 SITRANS Probe LU (PROFIBUS PA) – QUICK START MANUAL Page EN-13
mmmmm
English
Activating SITRANS Probe LU
Power up the instrument. SITRANS Probe LU (PROFIBUS PA) starts in RUN mode, and the LCD
displays the output of AIFB1.
Network Address (default 126)
Verifying/changing the device address via the handheld programmer
1. Press Mode to activate PROGRAM mode
and open Menu level 1.
2. Press Right ARROW twice to navigate to
PROFIBUS Address.
3. Press Right ARROW again to open Edit
mode: the PROGRAM icon will flash.
4. Key in a new value and press Right ARROW
to accept it. (The LCD displays the new value,
PROGRAM icon disappears, and the last menu
digit flashes to indicate Navigation mode.)
5. Press Mode to return to RUN mode.
Performing calibration via PROFIBUS PA
To use PROFIBUS PA, you will need a PC configuration tool: we recommend SIMATIC PDM.
Please consult the operating instructions or online help for details on using SIMATIC PDM. (An
Application Guide
SMPI PROFIBUS PA instruments and SIMATIC PDM
is available on our
website at: www.siemens.com/probelu
.)
Note: Keep infrared devices such as laptops, cell phones, and PDAs, away from SITRANS
Probe LU (PROFIBUS PA) to prevent inadvertent operation.
Notes:
• Local programming must be enabled, to allow changes (see
Local operation enable
on
page 12).
• CLEAR can be used to clear the field.
•Press Right ARROW to open Edit mode: the PROGRAM icon flashes.
•Press Left ARROW to cancel Edit mode: the Menu number flashes (the PROGRAM
icon is not visible).
Menu level: last
digit flashes in
Navigation mode
Program icon:
flashes in Edit
mode
Right-most digit
flashes in
Navigation mode
To Next Page
Loading...
