Siemens sitrans PROBE LU - Offsets and Measuring Limits

Page 76 SITRANS Probe LU (PROFIBUS PA) – INSTRUCTION MANUAL 7ML19985JB02
mmmmm
H: Parameters
1.3.5. Write Locking
Prevents any changes to parameters via PDM or the handheld programmer.
Open the menu Device – Write Locking, and select On or Off.
1.3.6. Contrast
Allows you to adjust the LCD contrast to compensate for different lighting
conditions.
Go to Identification > Device > Contrast, and enter the desired value. To increase
the contrast, enter a higher value.
1.3.7. Language
Selects the language to be used on the LCD.
1.4. Statistics
1.4.1. Powered Hours
Number of hours the unit has been powered up since manufacture.
Open menu View – Wear.
1.4.2. Poweron Resets
The number of power cycles that have occurred since manufacture.
Open menu View – Wear.
1.4.3. Internal Temperature
The internal electronics temperature.
Open menu View – Peak Values, and select the tab Temperature.
Hand
programmer
values
2457 (unlock value) *
Off (enables programming)
any other value
On (disables programming)
Values
Range: 0 to 10
Default: 3
Hand
programmer
values
0*
English
1
German
2
French
3
Spanish
Value (view only)
Degrees C