EasyManua.ls Logo

Siemens SlMATlC S5-010W - Page 9

Siemens SlMATlC S5-010W
27 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1.
Description
1.3
Principle of operation
Interface
module
6ES5772-OAA12
General:
The
6ES5772-OAA12 modules enable up to 15 individual S5-010
The master PC
must have eiaht inputs and
13
outputs for 24 V. The
programmable controllers to be interfaced to a higher-ranking PC peripheral bus carries the
fdlowing signals:
(e.g.
S5-150), one such module being needed for each PC. This
arrangement is particularly meaningful when the
PCs of several
-
8
bits for
8
binary signals from the SS-010
W
PC
autonomous individual machines of, for example, a production line
(inputs of the master PC)
are to oaerate under a hiaher-rankina control svstem.
-
8
bits for
8
binary signals to the S5-010
W
PC
v
(outputs of the master PC)
Signal interchange takes place on a peripheral bus which is looped
-
4 bits for addressing the interface modules
through all the interface modules, starting from the master PC.
-
1 bit for lowlhigh byte selection
It should be pointed out that a radial arrangement of the peripheral
In addition to these 21 signal lines a further two are needed for the
bus is possible and may be the better solution for many applica-
24 V supply so that a 24-core
SlMATlC cable can be used.
tions. It avoids, for example, having to shut down all the S5-010
PCs when changing modules in only one of them.
Fig.
10 Interfacing
up
to 15 55-010 Wprogrammable controllers to a master
PC
PC
2
PC;
3
No
of
Es
5
15
All inputs and outputs, including the address bits, are galvanically The outputs have an output load capability of 30 mA and are
isolated
from the S5-010 PCs, which means that the individual PCs
current-limited. Since the peripheral bus runs through n
d
15 inter-
can have different reference potentials. The +24 Vand
M
(reference face modules, all the eight outputs of an interface module are
potential) connections to the interface module must be taken from
connected in parallel with n
-
1
outputs of the other interface
the power source supplying the
inputloutput modules of the master
modules. The mutual loading of the outputs due to the paralleling is
PC.
n
X
1 mA. The load capability of each output is reduced by this
amount.

Related product manuals