1 Release the locking lever by turning it counter-clockwise by 90
°.
2 Press lightly against the upper or lower edge of the display to move
the monitor into the desired tilt position.
1 Turn the wheel clockwise to raise the monitor.
2 Turn the wheel counter-clockwise to lower the monitor.
The footswitch is used to start and stop the MR measurement in the
examination room.
(1) Hose
(2) Hose connector
(3) Pushbutton unit
(4) Footswitch Start/Stop
For additional support, labels can be affixed to the footswitches.
Start label
Stop label
MR measurements with the footswitch are only possible for protocols
that were configured for manual start-up. This is the case e.g. for
protocols with MR measurements after administering contrast
medium.
Adjusting the monitor height
Operating the footswitch
Performing the measurement
MR system components 3
MAGNETOM Skyra
fit
| syngo MR E11
79
Print No. M6-04401.621.02.02.02
To Next Page
Loading...
