TC35i AT Command Set
2.14 AT^SCFG
s
m
obil
e
TC35i_ATC_V02.07 Page 55 of 439 1/30/04
Confidential / Released
AutoExec AT command String
This parameter specifies the automatically launched AT command. It is executed as entered online, e.g. com-
mand concatenation is possible if supported by the given commands. If serial multiplex mode is activated
(
AT+CMUX) the first logical channel is used, i.e. CSD calls (data or fax) could be set up. If the TC35i is busy on
the serial channel command execution will be delayed until ongoing action is finished.
In contrast with
AT%D repeated autoexecution events are not ignored during a call triggered by such an event.
The first two characters of the automatically launched AT command shall be "at" and its length shall be less than
25 characters.
Please refer to examples below.
Value will be saved while switching off the TC35i via AT commands (e.g.
AT+CFUN or AT^SMSO) and restored
on next power up.
AutoExec Command Mode
This parameter specifies details regarding the behavior of the TC35i when the AT command starts to be exe-
cuted.
Value is interpreted as a bit field, unused bits are reserved for future use (RFU) and shall be set to 0.
When a call is released by autoexec activity, no release indication may be issued on the first logical channel.
If during a data call the TC35i temporarily enters command mode via
+++ no AT command will be executed if
<AutoExecMode> specifies 'Ignore ongoing calls'.
Value will be saved while switching off the TC35i via AT commands (e.g.
AT+CFUN or AT^SMSO) and restored
on next power up.
0...255
AutoExec Command Index
This parameter specifies the command storage index. If the range comprises more than one storage the related
<AutoExecType> variant may be started in parallel with different parameter settings.
The following table shows the index ranges of the different
<AutoExecType> variants.
<AutoExecATC>
(str)(+CSCS)
<AutoExecMode>
(str)(+CSCS)
Bit Mask
hex
Mask
dec
Control
D
0
D
1
0x00
0x01
0x02
0x03
0
1
2
3
00: Ignore ongoing calls
01: Wait for all calls have ended
10: Dismiss any ongoing call
11: RFU
D
2
0x04 4 0: One shot action
1: Periodically action (for "AutoExec/
Period" only)
D
3
0x08 8 RFU
D
4
0x10 16 RFU
D
5
0x20 32 RFU
D
6
0x40 64 RFU
D
7
0x80 128 RFU
<AutoExecIndex>
(str)(+CSCS)