Siemens TC35i User Manual

TC35i AT Command Set
2.14 AT^SCFG
s
m obil e
TC35i_ATC_V02.07 Page 56 of 439 1/30/04
Confidential / Released
Value will be saved while switching off the TC35i via AT commands (e.g. AT+CFUN or AT^SMSO) and restored
on next power up.
AutoExec AT Command Period
Parameter specifies the period after which
<AutoExecATC> will be executed. Format is "hhh:mm:ss", where
characters indicate hours and minutes. This parameter applies for
<AutoExecPeriod>=1 only.
Due to the internal activity and network signalling an execution delay of several seconds may occur for the over-
all procedure.
Value will be saved while switching off the TC35i via AT commands (e.g.
AT+CFUN or AT^SMSO) and restored
on next power up.
000:00:05...240:00:00
Notes
• Automatic dialing on DTR line activation can also be enabled via AT%D. However, AT%D and <AutoExec-
Type>
=0 shall not be used at the same time. If both kinds of DTR triggered autoexecution are enabled only
AT%D related action will be performed.
• Please keep in mind, that each time the ME is restarted the timers of all autoexec actions configured with
<AutoExecType>=1 and <AutoExecPeriod> will be reinitialized and restarted. As a result, an autoexec
action configured at a time later then a scheduled automatic restart would never be executed.
• Please be careful using
<AutoExecType>=1 with small period values and shutdown or reset AT commands,
since only little time remains to change these settings again after TC35i restart.
• If
<AutoExecATC> uses AT commands containing secret data, this information may be retrieved with
AT^SCFG?. For instance, this applies if using AT+CPIN.
<AutoExecType>
value
<AutoExecType>
event
Valid Indicies
0 ASC0 DTR line activation 0
1 <AutoExecPeriod> expiration 0-2
<AutoExecPeriod>
(str)(+CSCS)

Siemens TC35i Specifications

General

Brand	Siemens
Model	TC35i
Category	Modem
Language	English