Siemens TP700 Comfort - Air Blast Option

For more technical support, please go to our website:
www.gillardcutting.com/technical
22
When the machine has detected the blade is broken, the following screen will
appear:
Simply acknowledge with the OK button and change the blade. Please follow the
procedure for changing a broken blade as detailed later in the manual (section F-B).
Air Blast (option):
This is an air blast output after each cut. This can typically be used to blow away cut
pieces from a conveyor.
This option can be enable or disable. The parameters to set are:
Delayaftercut:  Itisthedelaybetweenthecutcompletionandthestartof
the air blast in milliseconds.
Duration:   Durationoftheairblastinmilliseconds.
ScrapTransitionDelay: Theairblastisautomaticallydisablewhenthemachine 
is cutting scrap. It is possible to set a delay to reactivate
the air blast after the transition of cutting bad to
good product. This avoids bad parts to blow away and get
mixed with the good ones. The delay is set in milliseconds.