For more technical support, please go to our website:
www.gillardcutting.com/technical
24
Scrap Mode:
The machine will cut a predetermined length (Scrap Length) when an external
signal indicates that scrap product is arriving. The machine will track the position
when the signal rises and falls to calculate the position of the scrap material as
it makes it way down the line to the blade. The options are either On or Off. The
parameters to set are:
Blade to Sensor (mm): This is the distance between the Scrap signal and the
blade in millimetres. It is very important that this is entered
accurately to ensure proper performance of the
scrap mode.
Scrap Length: The length in millimetres that the machine will cut when
Scrap mode is active.
To Next Page
Loading...
