For more technical support, please go to our website:
www.gillardcutting.com/technical
25
Atomiser:
The machine will lubricate the blade as it passes through the bushes to prevent
build-up of debris. The mode is either On or Off.
Heaters:
The heaters warm up the product providing a better quality on the cut. The heaters
must be switched on after a power cycle. The different parameters can be set in the
following screen:
Heater Enable Switch: Turn the heating element on/off. The power will also be cut
whenever the machine becomes unsafe or when it
is switched off on the unit itself.
NOTE: the fan will continue to run at the set speed to help
cool the heating element.
Temperature Setpoint: This is where the operator can set the temperature they
wish the heater to produce. This value will also be
show graphically through the gauge which will show the
current set point in relation to the maximum value.
To Next Page
Loading...
