Siemens TUTORbit POL895 User Manual

78
TUTORBIT
COSMOGAS
6 - USE
Parameter Description
Access
level
Adjustment
range
Default value
Custom
value
Default gateway
Installer 192.168.4.150
Pref. DNS server
Installer 194.25.2.129
Altern. DNS server
Installer 194.25.2.130
Host name
Installer POL687_EB5A02
MAC address
Installer
00-A0-03-EB-5A-02
Link
Installer Inactive
100 Mbit
Installer Inactive
Special settings
Installer
Controller
Installer Active...Inactive Active
Port
Installer 0...65535 4242
Web HMI (HTTP)
Installer Active...Inactive Active
Port
Installer 0...65535 80
FTP
Installer Active...Inactive Active
Port
Installer 0...65535 21
TFTP
Installer Active...Inactive Active
Port
Installer 0...65535 69
After changing the values
Installer
Reset required!!!
Installer
After changing the values
Installer
Reset required!!! Each time this menu is changed, you need to save and reset in order to load the changes in the temperature
controller
Installer
Save/Restore TutorBit data save settings
Installer
SD-card SD card state: “No card” = there is no SD card;
“Read only” = The SD card is read-only; “ReadWrite” = The SD card can be read and overwritten;
Installer
No card; Read only; ReadWrite;
Formatting SD card formatting command
Installer Executed Executed
>
Installer No
Available Memory Free space on the SD card
Installer Value Value
Save Cong. In SD Save TutorBit conguration in the SD card
Installer Executed-√ Executed
>
Installer
Load conf. From SD Load TutorBit conguration from the SD card
Installer
Executed- Partial-√
Executed
>
Installer
Set Default Set factory settings and parameters
Factory Executed-√ Executed
BSP version Command for loading a new software version from the SD card
Installer Executed-√ Executed
Sett.service load Load the Service parameters and settings, as saved in Conguration>DT Control>Save/Restore> Sett.service
save
Installer Executed-√ Executed
Continued on the next page

Siemens TUTORbit POL895 Specifications

General

Brand	Siemens
Model	TUTORbit POL895
Category	Controller
Language	English