Siemens ZIC-4A User Manual

Siemens Industry, Inc.
Building Technologies Division
P/N 315-033050-1510
Figure 5
Installing The ZIC-4A
INSTALLATION The ZIC-4A plugs perpendicularly into one slot in the CC-5 card-cage via two 96-pin
DIN connectors and can occupy any slot in the card cage. (Refer to Figure 5.)
Insert the ZIC-4A card into the card guides right side up (lettering on the front panel
is legible).
Slide the card in until the card edge connectors contact the recep-
tacles on the motherboard.
Verify that the DIN connectors of the card and the card-cage aligned
properly. The card can only plug in one direction to the card cage, if it
does not align, DO NOT FORCE the card.
Place thumbs on the front panel adjacent to the captive screws and
gently apply even pressure on the card until the connectors seat in the
receptacles on the motherboard. Secure with the captive screws.
If the ZIC-4A is being powered from an external source, verify that E5 has the proper
voltage and proper terminal connections.
ELECTRICAL RATINGS
roenalPkcaBV42
tnerruCrewoPlanretxE
wolebETONeeS
tnerruCV42lanimreTwercStnerruCeciveDlatoT
tnerruCenalPkca
BV2.60
tnerruCybdnatSV42Am98
:ETON .A4-CIZehtfotkCCIZhcaefoepytgniriwdnaegasuehtnotnednepedsitnerrucV42ehT
.epytgniriwdnaegasuenozhcaerofswardtnerrucderiuqerehterawolebdetsiL
tnemeriuqeRtnerruCA4-CIZ
egasUenoZ
tnerruCtuptuO
tnemeriuqeR
tnerruCAssalC
tnemeriuqeR
desUtoN00
CANAm71Am6
.cnyS-ebortSAm71Am6
.cnysnU-ebor
tSAm71Am6
ASU-eiTlapicinuMAm430
adanaC-eiTlapicinuMAm710
enoZgnisaeleRAm710
mralA-eniLdesaeLAm710
elbuorT-eniLdesaeLA
m710
vpuS-eniLdesaeLAm710
yramirP-rewolloFlleB00
yradnoceS-rewolloFlleBAm71Am6
enoZrekaepSAm43Am6
dedoC-CANAm71Am6
Am9
8=tnerruCybdnatSA4-CIZ

Siemens ZIC-4A Specifications

General

Brand	Siemens
Model	ZIC-4A
Category	Control Unit
Language	English