Siemens ZIC-4A User Manual

Siemens Industry, Inc.
Building Technologies Division
P/N 315-033050-157
SGNITTESREPMUJDNAHCTIWSA4-CIZ
EGASUENOZ1S2SNOITISOPREDAEH
CANlamroNFFO6-4,3-1
eiTlapicinuMlamroNFFO6-4,3-1
enoZgnisaeleRlamroNFFO6-4,3-1
eniLdesaeLl
amroNNO-)enoZ(WS6-4,3-1
yramirP-rewolloFlleB
)ylnO1enoZ(
lamroNffOFFO6-4,3-1
yradnoceS-rewolloFlleBlamroNFFO6-4,
3-1
gnidoCenoZlamroNFFO6-4,3-1
slleBdedoClamroNFFO6-4,3-1
enoZrekaepSlamroNFFO6-5,2-1
Programming Options In order to perform its intended operation, the ZIC-4A card must be programmed
using the Zeus Programming Tool. The ZIC-4A card and its Out Ckt properties must
be set prior to normal operation.
In the Zeus Programming Tool, highlight the selected ZIC-4A card in the Physical
View and open the Detail View - Properties to modify and/or define the following
ZIC-4A card properties:
HNET Address This address must match the address
set in the ZIC-4A hardware.
Slot Location This defines the location where the
ZIC-4A is inserted in the CC-5.
Base Language Custom Message The message associated with the ZIC-4A
card.
Alternate Language Custom Message The message associated with the ZIC-4A
card in an alternate language.
ZIC Card 24V Power Source Select back plane or screw terminals.
Each ZIC-4A card is subdivided into four output circuits that can be programmed
independently of each other. In the Zeus Programming Tool, highlight the selected
ZIC-4A Output Ckt in the Physical View and open the Detail View - Properties to
modify and/or define the following ZIC-4A output circuit properties:
Device Address Shows preset address of ZIC card output.
Base Language Custom Message The message associated with the ZIC-4A
output circuit.
Alternate Language Custom Message The message associated with the ZIC-4A
output circuit in an alternate language.
Device Usage Signal
ZIC Circuit Usage Select usage required (see list).
ydaetSCANmrlAeniLdesaeL
dedoCCANyramirPloflleB
cnySebortSnroHyradnoceSloflleB
)ebortSnroH(ylnOnroH.liSrekaep
SV52
cnySebortSrekaepSV07
cnySnUebortSrekaepSV001
eiTlapicinuMenoZgnisaeleR
Degrade Mode Alarm Activation Determines if Degrade Alarm will activate
the ZIC-4A circuit when asserted.

Siemens ZIC-4A Specifications

General

Brand	Siemens
Model	ZIC-4A
Category	Control Unit
Language	English