115
Parameter Function
Stop bit
Default setup is 1. Please set according to the speed dome dial switch
setup.
Parity Default setup is none. Please set according to the speed dome dial
switch setup.
Save You can click save button after you complete setup for one channel,
or you can complete the whole setups and then click save button.
Refresh Click this button to get device latest configuration information.
7.3.2.9 Default & Backup
Default: Restore factory default setup. You can select corresponding items.
Backup: Export current configuration to local PC or import configuration from current PC.
Please refer to
X471H471H471HFigure 7-43X.
Please note system can not restore some information such as network IP address.
Figure 7-43
Please refer to the following sheet for detailed information.
Parameter Function
Select All Restore factory default setup.
Export
Configuration
Export system configuration to local PC.
Import
Configuration
Import configuration from PC to the system.
7.3.3 Advanced
7.3.3.1 HDD Management
HDD management includes net storage management and local storage management.
Please note, if you want to use local storage function, your storage device need to support
current function.
To Next Page
Loading...
