SIGLENT TECHNOLOGIES SDG1062X User Manual

SIGLENT
SDG1000X User Manual 93
Figure 2-50 System Information Interface
8. Update
The software version and configuration file of the generator can be updated
directly via U-disk. Follow the steps below:
1. Insert U-disk with firmware update file (*.ADS) and configuration file
(*.CFG) to USB host interface on the front panel of the generator.
2. Press Utility → Page 1/2 → Firmware Update. Or press Store/Recall
directly.
3. Select the firmware file (*.ADS) and choose Recall to update the system
software.
4. After the updating is finished, the generator will restart automatically.
5. Press Utility → Page 1/2 → Firmware Update. Or press Store/Recall
directly.
6. Select the configuration file (*.CFG) and choose Recall to update the
configuration file.
7. After the updating is finished, the generator will restart automatically.
Note:
1. Don‘t cut off the power during the generator is being updated！

SIGLENT TECHNOLOGIES SDG1062X Specifications

General

Brand	SIGLENT TECHNOLOGIES
Model	SDG1062X
Category	Portable Generator
Language	English